Cisco Systems CGS252016S8PC Bedienungsanleitung PDF herunterladen (Seite 46)

2-24

Cisco CGS 2520 Hardware Installation Guide

78-19377-02

Chapter 2 Switch Installation

Connecting Devices to the Ethernet Ports

Figure 2-23 Removing the SD Flash Memory Card

Step 5 Push the replacement card (upside down) into the slot, and press it firmly in place. The card is keyed so

that you cannot insert it the wrong way.

Step 6 Begin replacing the cover by placing the SD slot cover tabs into the hinge.

Step 7 Close the cover, and use a ratcheting torque number 1 Phillips screwdriver to torque the screw to

4.5 in-lb.

Connecting Devices to the Ethernet Ports

This section covers the following procedures:

• Connecting to the 10/100 and 10/100/1000 Ports, page 2-25

• Connecting to the 10/100 PoE Ports, page 2-25

Table 2-1 Ethernet Cables (Auto-MDIX Disabled)

Device Crossover Cable

1. 100BASE-TX and 1000BASE-T traffic requires twisted four-pair, Category 5, Category 5e, or Category 6 cable. 10BASE-T

traffic uses Category 3 or Category 4 cable.

Straight-Through Cable

Switch to switch Yes No

Switch to hub Yes No

Switch to computer or server No Yes

Switch to router No Yes

Switch to IP phone No Yes

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 93 94

Keine Kommentare

Cisco Systems CGS252016S8PC Bedienungsanleitung Seite 46