Cisco Systems D200 Bedienungsanleitung PDF herunterladen (Seite 8)

19-8

Cisco ONS 15454 SDH Procedure Guide, R7.2

October 2007

Chapter 19 DLPs D200 to D299

DLP- D211 Provision CE-1000-4 Ethernet Ports

DLP-D211 Provision CE-1000-4 Ethernet Ports

Note You can provision SONET contiguous concatenated (CCAT) or virtual concatenated (VCAT) circuits for

the CE-1000-4 before or after provisioning the card’s Ethernet ports and/or packet-over-SDH (POS)

ports. See the “NTP-D323 Create an Automatically Routed High-Order Circuit” procedure on page 6-55

or the “NTP-D283 Create an Automatically Routed VCAT Circuit” procedure on page 6-97, as needed.

Step 1 In node view, double-click the CE-1000-4 card graphic to open the card.

Step 2 Click the Provisioning > Ether Ports tabs.

Step 3 For each CE-1000-4 port, provision the following parameters:

• Port Name—If you want to label the port, enter the port name.

• Admin State—Select the service state for the port. See the “DLP-D214 Change the Service State for

a Port” task on page 19-10 for more information.

• Flow Control—Select the flow control for the port. Possible values are None, Symmetrical, and

Pass Through.

• Auto Negotiation—Click this check box to enable autonegotiation on the port (default). If you do

not want to enable autonegotiation control, uncheck the box.

• MTU—If you want to permit the acceptance of jumbo size Ethernet frames, choose 10004 (default).

If you do not want to permit jumbo size Ethernet frames, choose 1548.

• Watermark—Select the flow control watermark for the port. To provision the Low Latency flow

control watermark, choose Low Latency from the drop-down list. The Flow Ctrl Lo and Flow Ctrl

Hi values change. To provision a Custom flow control watermark, choose Custom from the

drop-down list.

Enter values in the Flow Ctrl Hi and Flow Ctrl Lo columns. The Flow Ctrl Lo value has a valid range

from 1 to 510 and the Flow Ctrl Hi value has a valid range from 2 to 511. The Flow Ctrl Lo value

must be lower than the Flow Ctrl Hi value.

Step 4 Click Apply.

Step 5 Refresh the Ethernet statistics:

a. Click the Performance > Ether Ports > Statistics tabs.

b. Click Refresh.

Purpose This task provisions CE-1000-4 Ethernet ports to carry traffic.

Tools/Equipment None

Prerequisite Procedures DLP-D60 Log into CTC, page 17-49

Required/As Needed As needed

Onsite/Remote Onsite or remote

Security Level Provisioning or higher

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 85 86

Keine Kommentare

Cisco Systems D200 Bedienungsanleitung Seite 8