Cisco Systems PA-POS-1OC3 Betriebsanweisung PDF herunterladen (Seite 70)

4-6

PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide

OL-6514-04

Chapter 4 Configuring the PA-POS-1OC3

Configuring the Interfaces

Step 5 Re-enable interfaces by doing the following:

a. Repeat Step 3 to re-enable an interface. Substitute the no shutdown command for the shutdown

command.

b. Repeat Step 4 to write the new configuration to memory. Use the copy running-config

startup-config command.

c. Repeat to verify that the interfaces are in the correct state. Use the show interfaces command

followed by the interface type and interface address of the interface.

Performing a Basic Configuration

Following are instructions for performing a basic configuration, which include enabling an interface

(with the no shutdown command) and specifying IP routing. You might also need to enter other

configuration commands, depending on the requirements for your system configuration and the

protocols you plan to route on the interface.

For complete descriptions of configuration commands and the configuration options available for the

interfaces of your port adapter, refer to the appropriate software documentation.

In the following procedure, press the Return key after each step unless otherwise noted. At any time,

you can exit the privileged level and return to the user level by entering disable at the prompt as follows:

Router# disable

Router>

VIP in the Cisco 7500 series

routers (7505, 7507, 7513)

show interfaces pos followed by

slot/port-adapter/port

(interface-processor-slot-number/

port-adapter-slot-number/

interface-port-number)

The example is for interface 0 in port adapter

slot 1 of a VIP installed in interface processor

slot 1.

Router#show interface pos 1/1/0

Pos 1/1/0 is administratively down, line

protocol is down

[Additional display text omitted from

this example]

Cisco 7600 series routers (7603,

7606, 7609, 7613) with

FlexWAN or Enhanced

FlexWAN

show interfaces pos followed by

slot/port-adapter/port

(module-slot-number/

port-adapter-bay-number/

interface-port-number)

The example is for interface 0 on a port adapter

in port adapter bay 0 of a FlexWAN module in

module slot 3.

Router# show interfaces pos 3/0/0

Pos 3/0/0 is administratively down, line

protocol is down

[Additional display text omitted from

this example]

1. For the Cisco 7206VXR router shelves in the Cisco AS5800, the interface specified in the above example would include a shelf number. For example,

the command show interface 5/3/0 specifies the OC-3 interface of the PA-POS-1OC3 in port adapter slot 3 of router shelf 5.

Table 4-3 Examples of the show interfaces pos Command for the Supported Platforms (continued)

PLatform Command Example

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 89 90

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco Systems PA-POS-1OC3 Betriebsanweisung Seite 70

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Router Cisco Systems PA-POS-1OC3