Cisco Systems PA-4T Bedienungsanleitung PDF herunterladen (Seite 51)

CHAPTER

Installing the PA-4T+ Interface Cables 7-1

Installing the PA-4T+ Interface Cables

To continue your PA-4T+ port adapter installation, you must install the port adapter cables and

conﬁgure the PA-4T+ interfaces. The instructions that follow apply to all supported platforms. Minor

differences between the platforms are noted. This chapter contains the following sections:

• Attaching PA-4T+ Port Adapter Interface Cables, page 7-1

• Replacing PA-4T+ Port Adapter Cables, page 7-2

Attaching PA-4T+ Port Adapter Interface Cables

On a single PA-4T+, you can use up to four synchronous serial connections. Use the following

procedure to connect a serial cable to the PA-4T+:

Step 1 Attach the appropriate serial cable directly to the receptacle on the PA-4T+ and tighten

the strain-relief screws. (See Figure 7-1.)

Note Port adapters have a handle attached, but this handle is not shown to allow a

detailed view of each port adapter’s faceplate.

Figure 7-1 Connecting PA-4T+ Serial Cables—Horizontal Orientation (Shown Without

Handles)

H9709

To CSU, DSU, or external

synchronous serial equipment

Strain-relief screws

FAST SERIAL, ENHANCED

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 75 76

Keine Kommentare

Cisco Systems PA-4T Bedienungsanleitung Seite 51