Cisco Systems PGW 2200 Betriebsanweisung PDF herunterladen (Seite 277)

5-3

Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide

OL-18083-01

Chapter 5 Migrating to Solaris 10 and Cisco PGW 2200 Softswitch Software Release 9.8

Required Software

Note The Cisco PGW 2200 Softswitch supports a live upgrade from the Sparc-based platforms to the

Opteron-based platforms. There is no service outrage during the upgrade. For detailed procedure of this

live upgrade, see the “Upgrading Lively from Sparc-based Platforms to Opteron-based Platforms”

section on page 5-21.

Required Software

You must have the following software:

• Cisco Solaris 10 Operating System Jumpstart Disk. There are two versions of this disk, one for each

of the supported platform types. If your host platform is a Sun Opteron-based platform, use the

Cisco Solaris 10 Operating System Jumpstart Disk for Opteron-based Platforms. Otherwise, use the

Cisco Solaris 10 Operating System Jumpstart Disk for Sparc-based Platforms.

• Cisco Solaris 10 Operating Environment CD. The latest version of the version is available at:

–

http://www.cisco.com/cgi-bin/tablebuild.pl/mgc-sol10-sparc (Sparc platform)

–

http://www.cisco.com/cgi-bin/tablebuild.pl/mgc-sol10-opteron (Opteron platform)

• Cisco Installation CD, which includes the new release of the Cisco PGW 2200 Softswitch software.

The latest version is available at:

–

http://www.cisco.com/cgi-bin/tablebuild.pl/mgc-973-sparc (Sparc platform)

–

http://www.cisco.com/cgi-bin/tablebuild.pl/mgc-973-opteron (Opteron platform)

License Installation

Before you begin installation, obtain and install a Cisco PGW 2200 Softswitch license file using the

instructions provided in “Installing the License File, page 3-15”.

Recording System Data

When you upgrade to Sun Solaris 10, you must reenter various elements of your system data, because

the installation overwrites your existing system data. To ensure that you have all of your system data,

record the contents of the following files:

• /etc/default

• /etc/defaultrouter

• Hostname files for each interface (such as /etc/hostname.hme0 or /etc/hostname./jointfilesconvert/99324/bge0)

• /etc/hosts.equiv

• /etc/group

• /etc/nsswitch.conf

• /etc/passwd

• /etc/resolv.conf

• /etc/shadow

1 2 ... 272 273 274 275 276 277 278 279 280 281 282 ... 435 436

Keine Kommentare

Cisco Systems PGW 2200 Betriebsanweisung Seite 277