Cisco Systems RF Gateway 10 Schnellstart Anleitung PDF herunterladen (Seite 10)

Step 1 Locate the threaded holes on the front sides of the chassis that align with the holes in the rack-mount bracket. Ensure

that you hold the front rack-mount bracket with the ear and holes facing outward and towards the front of the chassis

(see

Figure 5).

Step 2 Install all six M5 undercut flat head screws (provided in the accessory kit) to secure each of the rack-mounting bracket

to the chassis. Three screws are installed on each end of the rack-mounting bracket.

Step 3 Repeat Step 1 through Step 2 on the other side of the chassis.

Step 4 Install the chassis in the rack. To install the Cisco RFGW-10 UEQAM in the rack, go to Installing the Cisco RFGW-10

UEQAM in a Rack, page 11.

Figure 5 Attaching the Front Rack-mount Brackets

Chassis Mid-Mounted Rack-Mount Bracket Installation

If you are rack-mounting the chassis using a mid-mounted configuration, then it provides for the chassis being recessed in the

rack or installed in a two-post rack.

Note Chassis installation handles cannot be installed if the chassis is to be mid-mounted.

Front rack-mount bracket

Front rack-mount bracket screws

Cisco RFGW-10 UEQAM Chassis

273684

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Keine Kommentare

Cisco Systems RF Gateway 10 Schnellstart Anleitung Seite 10