Cisco Systems RF Gateway 10 Schnellstart Anleitung PDF herunterladen (Seite 9)

Caution Ensure that the captive screws are secured tightly prior to loading the handles to prevent injury or damage to the

chassis.

Figure 4 Attaching the Chassis Installation Handles to the Cisco RFGW-10 UEQAM

After the chassis rack-mount brackets are installed, additional handles can be installed onto the front of the rack-mount

brackets. The rack-mount brackets allow a low and high installation of the handles onto the bracket depending on the chassis

installation (low or high in the rack).

Attaching the Chassis Rack-mount Brackets

This section explains how to attach the front and the mid rack-mount brackets to the chassis. Before installing the chassis in the

rack, you must install the rack-mount brackets on each side of the chassis.

Note The rear RF cable management bracket is installed on the chassis after you install the chassis rack-mount brackets and

mount the chassis in the rack.

Chassis Front Rack-mount Brackets Installation

To install the front rack-mount brackets on a Cisco RFGW-10 UEQAM, complete the following steps:

273450

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Keine Kommentare

Cisco Systems RF Gateway 10 Schnellstart Anleitung Seite 9